Stihl MS 362 Manual page 42

2
The crankshaft (1), connecting rod
(2) and needle bearing form an
inseparable unit. Always replace as
a complete unit.
– Check the two halves of the
crankcase and ball bearings and
replace if necessary, b 6.6.1
Before installing, clean the
crankshaft with a standard
commercial, solvent-based
degreasant containing no
chlorinated or halogenated
hydrocarbons.
Installing
Ignition side of crankcase
Take care not to damage the
crankshaft stub.
Sealing faces must not be damaged
in any way.
: Position the tapered stub of the
crankshaft (arrow) above the ball
bearing at the ignition side.
MS 362, MS 362 C
– Wear protective gloves
1
to reduce risk of burn injury.
– Heat the inner bearing race to
about 150°C (300°F).
: Push the crankshaft home as far
as stop.
This operation must be carried out
very quickly because heat is
absorbed by the crankshaft, and the
inner bearing race shrinks.
1
If it is not possible to heat the inner
bearing race, use service tool 5910
007 2200 or 5910 007 2201 to install
the crankshaft.
– Use drilled plate 5910 893 2103.
: Screw the threaded sleeve (1)
5910 893 2420 onto the spindle
as far as stop.
Coat tapered stub of crankshaft with
oil.
: Position the tapered stub of the
crankshaft (arrow) above the ball
bearing at the ignition side and
push it home.
2
1
: Position the screw sleeve (2) on
the crankshaft thread (1) and
screw it into place.
.
41