Stihl MS 362 Manual page 101

High speed screw
The high speed screw H has a
limiter cap, which has to be
removed before the screw is
removed.
: Screw the puller (1) 5910 890
4500 counterclockwise into the
limiter cap – left-hand thread.
2
1
: Rotate the limiter cap until the lug
(2) is in line with the slot (1).
1
: Pull out the limiter cap (1).
100
– Take out the high speed
screw (H).
Always install a new limiter cap.
1
: Inspect the tip (arrow) for
damage or wear and replace the
high speed screw (H) if
necessary.
– Screw down the high speed
screw (H) as far as stop.
– Continue with pre-installing
limiter cap.
Pre-installing limiter cap
1
: Push the new limiter cap (1) on to
the high speed screw (H) as far
as the detent (arrow) – do not
push fully home.
The basic setting is performed
through the pre-installed limiter cap
with screwdriver 5910 890 2304.
– Reassemble in the reverse
sequence.
– Carry out the basic setting,
b 12.7.1
12.7 Adjusting the Carburetor
12.7.1 Basic Setting
The basic setting is necessary only
if the high speed screw (H) or low
speed screw (L) has to be replaced
or after cleaning and adjusting the
carburetor from scratch.
It is necessary to carry out the basic
setting after removing the limiter
cap.
The carburetor, air filter and
grommet are installed, the adjusting
screws fitted and the new limiter cap
pre-installed.
– Check chain tension and adjust if
necessary.
– Inspect the spark arresting
screen (if fitted) and clean or
replace if necessary, b 3.7 or
b 6.1
– Check the air filter and clean or
replace if necessary, b 12.1
MS 362, MS 362 C