Stihl MS 362 Manual page 82

1
: Remove the handle molding (1).
2
: Take the throttle rod (1) out of the
guide (arrow) and disconnect it
from the throttle trigger (2).
1
: Use a drift (2) to drive out the
pin (1).
MS 362, MS 362 C
2
1
: Remove the throttle trigger (1)
with torsion spring (2).
1
2
1
– Check the throttle trigger (1) and
torsion spring (2) and replace if
necessary
Installing
2
: Attach the torsion spring (1) to
the trigger (2) – note the installed
position (arrow).
2
1
: Place the throttle trigger (1) in the
handle and line up the holes in
the trigger and handle.
3
: Use a drift (2) to center the
throttle trigger (1).
: Drive home the pin (3) until it is
recessed by same amount at
both sides.
2
: Attach the throttle rod (1) to the
throttle trigger (2) and fit it in the
guide (arrow).
1
1
2
1
81