Air Valve - Stihl MS 362 Manual

Installing
1
– Note installed positions of
metering diaphragm (2) and
gasket (1).
: Fit the gasket (1) and metering
diaphragm (1) on the pegs
(arrows).
1
: Position the end cover (1) so that
the lever (arrow) points in the
direction of the choke shutter.
– Move the end cover (1) a little
until the pegs engage the holes in
the end cover.
MS 362, MS 362 C
2
: Fit the screws (arrows).
– Check position of metering
diaphragm and gasket, then
tighten down the screws firmly in
a crosswise pattern.
The end cover must be in line with
the edge of the carburetor body.
1
: Check operation.
– Throttle shaft lever (1) must
engage the air valve lever (2).
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
12.6.2 Inlet Needle
1
– Remove the metering
diaphragm,
b 12.6.1
: Take out the screw (1).
2
: Remove the inlet control lever (1)
with
spindle (2) out of the inlet
needle's groove.
The small spring under the inlet
control lever may pop out.
2 1
95