Stihl MS 362 Manual page 28

1
2
– Check the brake cable (1) and
retainer (2), replace if necessary
Disassembling the brake cable
and retainer
3
2
: Loosen the clamp screw (1) and
take out the adjusting screw (2).
– Pull out the brake cable (3) and
replace the retainer.
MS 362, MS 362 C
Installing
: Push the long hook (1) of the
brake cable into the hole (arrow)
and screw home the adjusting
screw (2) as far as stop.
1
: Push the short hook of the brake
cable (1) up through the slot
(arrow) from below.
: Push the short hook (1) through
the hole (arrow).
2
1
: Push the brake cable (1) into the
bore (arrow) in the brake lever.
1
1
: Push the brake cable grommet
(1) into the housing bore (arrow)
until it is properly seated.
1
: Push the lugs of the brake cable
retainer (1) into the seats
(arrows) as far as stop.
– Insert and tighten down the screw
(2) firmly.
1
2
1
27