Stihl MS 362 Manual page 43

1
: Turn the spindle bolt (1) to
position the drilled plate 5910 893
2103 against the ignition side of
the crankcase and line it up so
that the number "22" is at the
bottom.
: Fit the M5x72 screws (arrows)
through the holes marked "22"
and tighten them down.
: Turn the spindle bolt (1)
clockwise.
– Install the ignition side of the
crankcase as far as stop.
The crankshaft turns when it is
being pulled into place with the
service tool. Therefore, make sure
the small end (1) of the connecting
rod always points upward to the
cylinder.
– Remove the service tool.
42
: At the ignition side, fit three
M5x72 screws (arrows) in the
holes to help alignment and avoid
twisting.
– Coat the straight stub of the
crankshaft with oil.
Installing
Clutch side of crankcase
Take care not to damage the
crankshaft stub.
Inspect and clean the sealing faces
on the clutch side of the crankcase
(including the cylinder sealing face)
– the sealing faces must not be
1
damaged in any way.
1
– Fit a new gasket (1) and locate it
on the sleeves (arrows).
Make sure the sleeves (arrows)
engage the holes and the gasket is
not pinched or twisted.
MS 362, MS 362 C