Starter Rope / Grip - Stihl MS 362 Manual

Installing
1
: Fit the rope rotor on the starter
post so that the inner spring loop
(arrow) engages the recess (1).
The recess in the hub of the rope
rotor is the anchor point for the
spring.
– Fit the cover washer.
– Install the pawls and spring clip,
b 8.3
– Install the starter rope, b 8.5
– Tension the rewind spring, b 8.6
– Lubricate pegs on pawls with
grease, b 15
– Reassemble all other parts in the
reverse sequence.
MS 362, MS 362 C
8.5

Starter Rope / Grip

– Remove the fan housing and the
segment, b 8.2
– Relieve tension of rewind spring,
b 8.4
The system will not be under
tension if the starter rope is broken.
– Remove remaining rope from the
rope rotor and starter grip.
Do not shorten the starter rope.
1
: Push the end of the starter rope
(1) out a little and undo the knot.
– Pull the starter rope out of the
rope rotor and fan housing.
1
: Use a suitable tool to pry the
nipple (1) out of the starter grip.
: Pull the starter rope (1) out of the
grip.
– Check the starter rope and
replace if necessary.
Do not shorten the starter rope.
Installing
: Thread the new starter rope (1)
through the top of the grip as far
as stop.
: Press the nipple (1) into the
starter grip until it engages.
1
1
1
63