Stihl MS 362 Manual page 93

1
: Push the air guide shroud's lugs
(1) between the ribs (arrow) on
the crankcase.
– Push the air guide shroud fully
home.
1
: Make sure the protective tube (1)
covers the opening (arrow).
1
: Fit and tighten down the screws
(1) firmly.
92
3
: Position the generator wire (1) so
that the insulating tube (2) is
against the guide (3).
– Fit the generator wire in the
guide (3).
1
2
: Position the wire (1) so that the
insulating tube (2) is against the
guide (3).
– Fit the wire in the guide (3).
1
1
2
: Push the wire (1) into the guide
(arrow).
: Push the connector sleeve (2)
into the heater switch.
– Install all other parts as in the
standard version.
– Tightening torques, b 2.5
12.5
3
– Remove the filter base, b 12.3
– Open the fuel tank cap and drain
the fuel tank.
– Collect the fuel in a clean
container, b 1
Disconnect the fuel hose only when
the tank cap is open.
Machines with Handle Heating
1
: Remove the heating element (1).
2
1
Carburetor
MS 362, MS 362 C