Stihl MS 362 Manual page 41

Use the tools in the service tool set
5910 007 2205 for removing and
installing.
: Take out the screws (arrows).
1
: The tensioner slide (1) must butt
against the thrust pad (arrow).
2
1
: Back off the spindle (1) in service
tool until it is clear of the
crankshaft stub.
: Push the service tool (2)
5910 890 2205 over the collar
screws (arrows), fit the nuts and
tighten them down firmly.
40
: Turn the spindle (1) clockwise
until the crankshaft stub is
pushed out of the ball bearing.
This operation releases the clutch
side of the crankcase and separates
the two halves.
– Install new ball bearings and oil
seals, b 6.6.1 and b 6.3
1
: Remove the gasket (1).
Ignition side of crankcase
2
1
Use the tools in the service tool set
5910 007 2201 for removing and
installing.
– Use drilled plate 5910 893 2103.
The drilled plate 5910 893 2103
can be added to and used with
service tool set 5910 007 2200.
All three drilled plates are included
in the new service tool set
5910 007 2201.
– Unscrew the spindle of service
tool (1) until the drilled plate (2)
butts against the crankcase
– left-hand thread.
: Service tool (1) with plate (2)
5910 893 2103 against the
ignition side of the crankcase so
that the number "22" (arrow) is at
the bottom.
: Insert three M5x72 screws (3) in
the holes marked "22" and
tighten them down until they butt
against the crankcase.
1
: Turn the spindle (1)
3
counterclockwise until the
crankshaft is pushed out of the
ignition side of the crankcase.
MS 362, MS 362 C