Stihl MS 362 Manual page 74

1
: Take out the screw (1) and
remove the bracket (2).
1
: Take out the screws (1).
: Ease the handlebar (1) sideways
and take it out of the guide
(arrow).
MS 362, MS 362 C
2
1
: Push the handlebar (1) out of the
lower guide.
1
During all the following procedures:
: To reduce the risk of a short
circuit, make sure the insulating
tubes completely cover the
connections.
1
1
– Pull the wires out of the guides.
: Tug the wiring harness (1) a little
to find the right connector.
1
: Push the insulating tube (1) in the
direction of the heating element.
: Separate the pin and socket
connector.
: Pull the generator wire out of the
guides (arrows).
It is not necessary to disconnect the
connector.
1
: Pull the connector sleeve with
wire (1) out of the heater switch.
73