Rewind Starter - Stihl MS 362 Manual

3.4

Rewind Starter

Condition
Starter rope broken
Starter rope does not rewind
Starter rope cannot be pulled out
far enough
Starter rope can be pulled out
almost without resistance
(crankshaft does not turn)
Starter rope is difficult to pull or
rewinds very slowly
MS 362, MS 362 C
Cause
Rope pulled out too vigorously as
far as stop or over edge, i.e. not
vertically
Normal wear
Very dirty or corroded
Insufficient spring tension
Rewind spring broken
Spring overtensioned
Guide peg on pawl or pawl itself is
worn
Spring clip on pawl fatigued
Starter mechanism is very dirty
Lubricating oil on rewind spring
becomes viscous at very low
outside temperatures (spring
windings stick together)
Decompression valve is not open
Remedy
Fit new starter rope
Fit new starter rope
Clean or replace rewind spring
Check rewind spring and increase
tension
Fit new rewind spring
Check rewind spring and reduce
tension
Fit new pawl
Fit new spring clip
Thoroughly clean complete starter
mechanism
Coat rewind spring with a small
amount of standard solvent-based
degreasant (containing no
chlorinated or halogenated
hydrocarbons), then pull rope
carefully several times until normal
action is restored
Open, check and replace
decompression valve if necessary
11