Invalid Password For Rca Setup - Fujitsu Siemens Computers PRIMESTATION Series Manual

PRIMESTATION as LAN Console
If there is still no output in the console window, the following command should
be executed on the connected system (e. g. using the rlogin command):
echo "\021\c" > /dev/console
5.8.4

Invalid password for RCA setup

An RCA can only be configured by the user Admin. If the valid password is not
known for this user, the RCA must be initialized (section "Switching on the RCA"
on page 35) and then reconfigured (section "Configuring the RCA" on page 47).
5.9 RCA commands
Accessing the RCA command interface
The commands for configuring and administering the RCA (RCA4) can be
executed in the Command Line Interface (CLI) of the RCA.
The CLI is accessed from the LAN Console using the xscon command:
Syntax:
<RCA Administration Access>
xscon
RCA administration access
Administration access to the RCA4 created under mkrca or
explicitly using mklancon, generally referred to as
<RCA SystemName>adm.
Access can also be enabled, if required, using the telnet command:
Syntax:
telnet < RCA SystemName
RCA systemname
The system name of the desired RCA
The relevant user name and associated password should be entered below in
both situations.
U41270-J-Z916-2-76
>
RCA commands
75