Connecting The Primestation To The Power Supply - Fujitsu Siemens Computers PRIMESTATION Series Manual

Overview of connections
V
Warning
You may only connect the power cable for the monitor to the monitor
socket on the system unit if the power consumption of the monitor is
less than 1.5 A (for 230 V) or 3 A (for 115 V). You will find the values
for the monitor's power consumption in the technical data for the
monitor itself or in the Operating Manual for the monitor.
4.4.5 Connecting the PRIMESTATION to the power
supply
Ê Check the power supply setting.
V
Warning
The value displayed or indicated with the arrow must conform with the
local power supply:
115 = 100 V to 125 V
Changing the power supply when it is set incorrectly
I
Your PRIMESTATION has a main switch on the rear of the system unit in
addition to the ON/OFF button on the front. The power supply setting is
found beneath this switch.
Ê Unscrew the plug-in element at the groove (1), rotate it and insert it back into
place again.
Figure 8: Setting the power supply
1= groove for inserting the screwdriver
18
230 = 200 V to 240 V
100 V - 125 V
1
PRIMESTATION
200 V - 240 V
1
U41270-J-Z916-2-76