Configuring The Rca - Fujitsu Siemens Computers PRIMESTATION Series Manual

PRIMESTATION as LAN Console
showlancon - Show the specified configuration entries
Syntax:
showlancon {<RCA SystemName> [<RCA PortNumber>]} | -n
<ConsoleName >| -a| -t <RCA Type>
The command arguments determine which configuration entries are to be
displayed.
RCA SystemName
All configuration entries belonging to the specified RCA are displayed.
RCA PortNumber
If a configuration entry is found for the specified TCP/IP port number –
admin is also possible on the RCA4 – which is served by the RCA, it is
displayed.
-n ConsoleName
The configuration entry belonging to the specified symbolic system name
is output.
-a
All configuration entries of all RCA types on the LAN Console are
displayed.
-t RCA Type
The permitted values are "3" and "4" for the RCA3 and the RCA4. All of
the configuration entries on the LAN Console of the specified RCA type
ate displayed.
Finally the current state of the associated RTTY monitor is displayed (e.g.
NOTRUNNING). If the -a argument is specified, the states of both RTTY
monitors are displayed assuming configuration entries exist for the associated
RCA types (for information on the RTTY monitor, see section "Status infor-
mation for the rtty monitor" on page 71).
5.4.2.3

Configuring the RCA

To be configured successfully, the RCA (RCA4) must be known and also acces-
sible in the LAN, and all serial console connections (V.24 lines) from the RCA to
the required RM or PRIMEPOWER (MR) servers must be implemented.
Since the RCA does not have a keyboard or display of its own, it is configured
from the LAN Console. The RCA is made known for this purpose using the arp
command, which means that it can be addressed after its initial boot, i.e. after
being powered on, from the LAN Console.
U41270-J-Z916-2-76
Configuration
47