Status Information For The Rtty Monitor - Fujitsu Siemens Computers PRIMESTATION Series Manual

PRIMESTATION as LAN Console
Trace level 0 is enabled by default. To set a different trace level - a maximum of
six levels are possible at present - this must be done separately for every
individual rtty monitor using the following rtty command:
level
rttyadm -T <
Error situations are logged in the basic level (trace level 0). The other trace
levels record additional information on the establishment and clearing down of
connections and other activities on the rtty monitor, including timeouts and
control of access to the RCA.
I
The extended trace mode (level > 0) should only be used briefly so that
the log file does not become too big.
5.7.2

Status information for the rtty monitor

The system uses the sacadm and pmadm tools to manage the rtty monitor.
These tools allow the state of the rtty monitor to be viewed and the monitor itself
to be manipulated - see the manpages for sacadm and pmadm.
5.7.3 Configuration entries for the LAN Console
When a configuration entry is created for the LAN Console with mklancon,
entries are generated in the rtty-specific /etc/saf/lanconsole/_pmtab or
/etc/saf/lanconsole1/_pmtab file, depending on the type.
Under the specified console name, the _pmtab file contains information about
the device used, the system name and port number of the RCA as well as
internal rtty details of the type of connection.
If the configuration entry relates to the RCA3, the encrypted password is also
stored in the /etc/saf/lanconsole/_shadow file in addition to each console name to
control access to the RCA3.
This information on the configuration entries can be displayed with the
showlancon command or the system tool pmadm -l -p lanconsole or
pmadm -l -p lanconsole1.
The mklancon configuration tool also modifies the system files /etc/uupc/Devices
and /etc/uucp/Systems.
U41270-J-Z916-2-76
> lanconsole | lanconsole1
Operating the LAN Console
71