System Unit Is In Standby Mode - Fujitsu Siemens Computers PRIMESTATION Series Manual

PRIMESTATION
4.5.1.2

System unit is in standby mode

The main switch (1) is in position I and the power LED (3) is not lighting. You
can enable the PRIMESTATION in this mode with the ON/OFF button (2). The
power LED (3) is described in greater detail in the next section.
4.5.1.3 System unit is switched on
The main switch (1) is in position I and the power LED (3) is lighting green. The
PRIMESTATION can be switched to standby mode using the ON/OFF button
(2).
To do this, press the ON/OFF button for 4 seconds.
I
This should only happen from the OBP (Open Boot Prom) or in the event
of an error.
"init 5" should always be used under Solaris to shut down to standby
mode.
4.5.2 Displays on the system unit
1
2 3
Figure 11: Free-standing PRIMESTATION
1. Power LED
If the power LED is lighting green, the PRIMESTATION is switched on.
The system then switches to the OBP or Solaris is started.
2. Hard disk indicator
U41270-J-Z916-2-76
Operating the PRIMESTATION
4
5
21