Installation And Generation - Fujitsu Siemens Computers PRIMESTATION Series Manual

Installation and generation

Teleservice on PRIMESTATION
If you encounter a generation or registration problem in the course of instal-
lation, call your SIEMENS IT Service hotline and report your Teleservice
problem (in Germany the number for the Siemens IT Service hotline is
0180/5-2202).
You can find out more about Teleservice on the Internet under
http://its.siemens.de/lobs/its/techinf/techinf_en.htm.
7.1 Installation and generation
Hardware installation
The following hardware is needed for Teleservice:
– A high-speed modem
– A 9/25-pin serial cable
– A telephone cable
– A power supply unit
– A power supply cable
The modem is connected via a serial connection cable to a free COM port on
the PRIMESTATION. The system should be turned off when connecting the
modem. Please refer to the documentation for the modem for information on
installation and operation.
Use the Western <-> TAE cable for the modem/telephone connection. The
Western connector is inserted in the modem and the TAE connector in the
telephone connection socket. Note that the TAE connector will only fit in a TAE
socket that has an N interface. A telephone is normally connected to an F
interface and is coded differently. There are also TAE sockets to which a
telephone and a modem can be connected. In this case, the modem is
connected on the left and the telephone in the middle.
The modem has a low-voltage on one side. Before connecting the power supply
unit to the modem, make sure the low-voltage switch is off. Finally plug the
power supply unit into a normal 230 V mains socket and turn the low-voltage
switch on again.
104
U41270-J-Z916-2-76