Select Program For Execution - Siemens SINUMERIK 840D Operator's Manual

6
"Program" Operating Area
6.10 Manage programs
Save
Load
standard
Set
standard

6.10.5 Select program for execution

Part
programs
Selection
Cycle Start
6-344
· Setting data (SEA)
· ...
If a job list exists, it is used as the basis for the backup procedure.
With the softkey "Save", you store the workpiece data of the selected
data types in the relevant workpiece directory.
If a job list exists in this workpiece directory, the data for all the
channels involved in the workpiece are automatically backed up. For
this, the main program selected at the beginning is searched for each
channel in the job list. The data are then backed up according to the
data types selected under its name.
With the softkey "Load standard" you can load the default settings for
input window "Save workpiece data".
Note:
Default settings are always supplied by SIEMENS.
Press this softkey if you want to define your own defaults in the input
window.
Function
Workpieces and part programs must be selected for
machining/execution before you press the NC Start key.
Operating sequence
Select a program:
Use the cursor keys to select a program in the
program overview, e.g. part programs, and
then press softkey "Selection".
The program name is displayed in the "Program name" window at the
top right.
You can start the part program by pressing "NC Start".
Select a workpiece:
A workpiece directory can be selected for machining in the currently
active channel.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
6
03.04
Ó Siemens AG, 2004. All rights reserved