Siemens SINUMERIK 840D Operator's Manual page 161

4
03.04
SKP:
Activate skip levels
Display activated skip levels
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Blocks that cannot be executed can be skipped (10 skip levels with
SW 6.4 and higher).
Blocks to be skipped are indicated in the part program by an oblique
"/" before the block number. The skip levels in the part program are
specified by "/0" or by "/" to "/9". You can activate/deactivate skip
levels in the following window:
Program control
SKP: Skip blocks
Skip /
Skip /1
Skip /2
Skip /2
Skip /3
Skip /4
Skip /5
Skip /6
Skip /7
Skip /8
Skip /9
This program control window is displayed only if more than 1 skip
level was set via machine data. Only the set skip levels are displayed.
Changes to machine data are described in Section 9.1.
If more than one skip level is active, the right column indicates
whether the PLC has transmitted the skip level selection to the NC.
This allows you to see from the top window which level
· is selected, but not yet
·
selected and
·
deselected and
·
deselected and
Machine Operating Area
4.6 Automatic mode
active
active,
active,
active,
not active.
4
4-161