Starting Angle For Thread Cutting - Siemens SINUMERIK 840D Operator's Manual

5
"Parameters" Operating Area
5.5 Setting data

5.5.5 Starting angle for thread cutting

Setting
data
Starting
angle
5-238
Function
For thread cutting, a starting position for the master spindle is
displayed as the starting angle. A multiple thread can be cut by
changing the angle when the thread cutting operation is repeated.
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Change starting angle:
Select softkey "Starting angle".
The "Starting angle for thread" window opens.
Enter a new value.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
X
Starting point
offset in °
Starting angle
for thread
(setting data)
Z
Ó Siemens AG, 2004. All rights reserved
5
03.04