Job List - Siemens SINUMERIK 840D Operator's Manual

2
Operator Components/Sequence of Operations

2.8 Job list

2.8

Job list

2-78
Function
With SW 5 and higher, it is possible to create a job list (loading list) for
each workpiece.
This list contains instructions which prepare the following for the
execution of part programs (in several channels if necessary):
· Parallel setup (LOAD/COPY) i.e.:
Load or copy main programs, subroutines and associated data
such as
- Initialization programs (INI)
- R parameters (RPA),
- User data (GUD),
- Work offset (UFR),
- Tool/magazine data (TOA/TMA),
- Setting data (SEA),
- Protection zones (PRO) and
- Sag/angularity (CEC)
from the hard disk of the HMI to the NC user memory.
· Preparations for the NC Start (SELECT) i.e.:
Select programs in different channels as well as starting
preparations for execution
· Parallel clearing (reversed LOAD/COPY) i.e.:
Remove/unload main programs, subroutines and associated data
from the NC working memory to the hard disk of the HMI
· Backup (in preparation for the next software version)
Notes
Parallel setup, preparations for NC Start, parallel cleanup and backup
can also be executed from the PLC.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
2
03.04
Ó Siemens AG, 2004. All rights reserved