Action Log; Version - Siemens SINUMERIK 840D Operator's Manual

8
03.04

8.3.7 Action log

Action
log

8.3.8 Version

Service
displays
Version
NCU
version
HMI
version
Option for
Compile cycles
Cycle
version
Definitions
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
An existing action log can be displayed. For additional information on
configuring the contents of the action log, see Installation and Start-
Up Guide HMI Advanced (IM4).
Function
The version data of the installed system software are output in the
Version display.
You can sort and save the version displays. Version displays saved
as ASCII files can be edited as required or sent to the hotline in the
event of an error.
Operating sequence
Press softkey "Service displays".
The horizontal softkey bars change.
Open the "Version" window in the "Service displays" menu.
The following softkeys are displayed:
"NCU version" for the version data of the NCU and
"HMI version" for the version data of the HMI.
If "compile cycles" are available on the NCK, the version is displayed.
"Cycle version" version data for each of the cycle packages (SW 6.3
and higher)
"Definitions" the version data for definitions
Use the "Page" keys to scroll up and down.
"Diagnosis" Operating Area
8.3 Service display
8
8-417