Undo And Redo In The Editor (From Sw 6.3) - Siemens SINUMERIK 840D Operator's Manual

6
"Program" Operating Area
6.4 Edit programs

6.4.2 Undo and redo in the editor (from SW 6.3)

Edit
"Ctrl" + "Z"
"Ctrl" + "Y"
6-272
Function
When editing a part program or a text file, you can undo complete
blocks in the editor. Once you undo a series of blocks, you can redo
the same number of blocks.
The two functions are called up by pressing the following key
combinations:
·
Press "Ctrl" and "Z" for
·
Press "Ctrl" and "Y" for
Operating sequence
Press the key combination "Ctrl" + "Z"
All changes in the entire block are undone. Repeat the key
combination to undo the previous change. The "CR" symbol at the
end of the block is also considered. This procedure can be repeated
until the last change or the set number of changes has been reached.
Press the key combination "Ctrl" + "Y"
The last changes undone in the editor are redone. This procedure can
be repeated until the last change is redone or the set number of
maximum changes has been reached.
The default number is 10 steps; this setting can be changed.
Setting the number to zero deactivates the function.
The "undo" and "redo" functions affect files in the operating memory,
not NC files or sub-areas.
References: /IAM/, IM4 Installation and Start-Up, Chapter 5
Functions/Parameters.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
03.04
"Undo"
"Redo"
Ó Siemens AG, 2004. All rights reserved
6