Siemens SINUMERIK 840D Operator's Manual page 134

4
Machine Operating Area
4.4 JOG mode
4-134
Other Information
As of SW 6.2:
Set zero point
Ext. WO frame
Toolholder
Tool reference
As of SW 6.3:
Workpiece reference
Cycles
See also the figure at the end of 4.4.6
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
corresponds to $P_SETFR
corresponds to $P_EXTFR
corresponds to $P_PARTFR)
corresponds to $P_TOOLFR)
corresponds to $P_WPFR)
corresponds to $P_CYCFR)
Ó Siemens AG, 2004. All rights reserved
4
03.04