Loading And Unloading The Workpiece/Part Program - Siemens SINUMERIK 840D Operator's Manual

4
03.04
Sub-
routines
Standard
cycles
User
cycles
Manu-
facturer

4.6.3 Loading and unloading the workpiece/part program

Program
overview
Download
HD->NC
Enabling of
Upload
NC->HD
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Display of all existing subroutines
Display of all existing standard cycles
Display of all existing user cycles
Display of all existing manufacturer cycles
Function
Workpieces and part programs can be stored in the NC memory
("Load" ) and erased from this memory again ("Unload") after they
have been executed.
In this way, it is possible to prevent the NC memory from becoming
unnecessarily overloaded because programs that are no longer
required can be erased immediately.
Operating sequence
The "Machine" operating area is selected.
The "Program overview" is open.
The vertical softkey bar changes.
Position the cursor in the directory tree on the workpiece/part program
that you wish to load.
The selected workpiece/part program is loaded from the hard disk into
the memory of the NC.
It is erased from the hard disk.
If the enable command (X) is set, the workpiece can be machined.
The highlighted workpiece/part program is loaded from the NC
memory to the hard disk.
The workpiece/program is erased from the NC memory.
Machine Operating Area
4.6 Automatic mode
4
4-143