Siemens SINUMERIK 840D Operator's Manual page 300

6
"Program" Operating Area
6.6 Display in the step editor (option from SW 6.4)
Step display variants
+
or
Collapsed step display
Expanded step display
Step editor operation
and
6-300
Combined step and standard editor view is not supported.
Two levels can be displayed in step view. Display is either expanded
for the entire step editor (main level and sublevel) or collapsed (main
level). By pressing the
- Keys + and
- Character –
you can switch between both display modes.
Operation is virtually identical to that of the ASCII editor, the only
different key functions for the step editor are described below:
· Steps like G code and wait markers are opened with the ASCII
Edit
editor.
· Standard cycles and contours (geometry processor, contour
Recompile
definition) are recompiled.
The full scope of editor functions is no longer available for the ASCII
editor.
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
6
03.04
Ó Siemens AG, 2004. All rights reserved