Siemens SINUMERIK 840D Operator's Manual page 301

6
03.04
OK
I
In step representation
Mark
block
Copy
block
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
6.6 Display in the step editor (option from SW 6.4)
Press INSERT to insert a new step before the currently selected step.
The editor window is automatically opened. The new step becomes
visible in the step display via the step name and - if configured - the
associated icons.
Default text is free DIN code with G icons.
New steps are also inserted via functions such as cycle support.
Pressing the keyboard shortcut CTRL and I will insert a predefined
SEFORM instruction in the SEditor.INI.
The step identifier is defined as:
SEFORM("step name", level, "icon") with
Step name Text is step display
Level 0 Main level, 1 sublevel (default = 0).
Icon Fine name of the icons as defined in the configuration
Default = Default icon, if configured, otherwise blank
(see SEdit.ini in /IAM/, IM4)
There are two types of notation for the icon:
Without path
With path
Each new work step which is started on the same level with
SEFORM, is the end of the preceding work step for this level.
Instead of the step name strings you can also write the text numbers
which are used in the file with the configured (alarm) texts. Enter them
in the format $8xxxx. They are then displayed in the currently active
language.
With collapsed display, the entire step is highlighted will all substeps
and can be copied or deleted as required.
With expanded display, the selected steps are highlighted.
Note
If you have switched between expanded and collapsed view while
work steps were highlighted, the highlighting is removed for the work
steps.
All selected steps are copied to the clipboard and can be inserted
anywhere in the active editor window or in the second editor window.
The clipboard is valid for each operating area at a time. An editor/dual
editor or multi-channel editor (see Section 6.8) which is e.g. activated
by the simulation or as a correction editor cannot access the clipboard
which contains data created in the Program operating area.
"Program" Operating Area
HMI searches for the icon
HMI opens the icon with the specified
absolute path.
6
6-301