Plug Specification; Ignition Wiring Replacement; Distributor Cap And Rotor Inspection; Distributor Advancer Inspection - Suzuki Samurai 1986 Service Manual

NOTE:
When replacing plugs, make sure to use new
plugs of specified heat range and size.

PLUG SPECIFICATION

3) Install new spark plugs. Tighten plugs to
specification.
4) Connect high tension cords to spark plugs.
DO NOT push cords for connection. Push
boots.
17. DISTRIBUTOR CAP AND ROTOR
INSPECTION
1) Inspect distributor cap and rubber caps for
cracks.
2) Inspect center electrode and terminals for
wear.
3) Inspect rotor for cracks, and its electrode
for wear.
4) Check to see that there are no excessive
closes in ventilation plug hole.
5) Repair or replace as necessary any compo-
nent which is found to be in malcondition as
described above.
NOTE:
Dust and stains found within distributor can be
cleaned by using a dry, soft cloth.

18. IGNITION WIRING REPLACEMENT

plugs, ignition coil and distributor.
and clamp them securely. DO NOT push
cords for connection. Push boots.
19. IGNITION~TIMING INSPECTION
Check to make sure that ignition timing is set
properly. If out of specification, adjust it.
Refer to p. 8-9 for inspection and adjustment
procedure.

20. DISTRIBUTOR ADVANCER INSPECTION

Check advancer for proper operation. Refer to
p. 8-9 for checking procedure.
Check vacuum hose for pinhole, crack or break.
Correct or replace if necessary.
1-13