Suzuki Samurai 1986 Service Manual page 72

b) Remove valve stem oil seal from valve guide,
and then valve spring seat.
NOTE:
Do not reuse oil seal once disassembled. Be
sure to use new oil seal when assembling.
Fig. 3-4-28
c) Using special tool (F), drive valve guide
out from combustion chamber side to valve
spring side (Figure 3-4-29).
NOTE:
Do not reuse valve guide once disassembled.
Be sure to use new valve guide (Oversize) when
assembling.
Fig. 3-4-29
3-14
1. Valve stem oil seal
2. Blade screw driver
3. Valve spring seat
NOTE:
Place disassembled parts except valve stem seal
and valve guide in order, so that they can be
installed in their original positions.
29) Remove flywheel, using special tool (A)
as shown.
Fig. 3-4-30 (A) Flywheel holder (Special tool
30) Remove oil level gauge guide from oil pump.
Fig. 3-4-3 1