Reverse & Low Speed Guide Pins; Gear Shift Lever Case; Installation - Suzuki Samurai 1986 Service Manual

12-4. INSTALLATION

Gear shift lever is installed by reversing removal
procedure. Some important steps will be explain-
ed in detail.
Reverse & Low Speed Guide Pins
Be sure to apply grease to select guide pins
before installing them into gear shift lever case.
Fig. 12- 11
When fitting low speed select guide pin into
gear shift lever case, tighten locating bolt while
pushing pin so that bolt goes in the groove
provided in the pin. Then install reverse select
guide pin in case and securely fit the locating
Fig. 12- 12
NOTE:
After each guide pin is installed, make sure that
flat surfaca @I at the tip of pin faces upward
(toward gear shift lever).
Fig. 12-13

Gear Shift Lever Case

When installing lever case to transmission
extension case, clean joint faces, and then apply
sealant (SUZUKI BOND NO. 1215, 99009
31110) to joint faces.
Fig. 12- 14
12-5