Suzuki Samurai 1986 Service Manual page 210

6. Disconnect heater blower motor and resistor
lead wires at the coupler.
7. Loosen heater case securing nut on the engine
room side.
Fig. 7-8
6. Remove heater ass'v.
Fig. 7-9
9. Remove heater blower motor.
Installation
Reverse the removal procedure for installation,
exercising care to the following.
1. Make definitely sure to insert holder plate
between holder and body,
2. When installing parts, be careful to prevent
wire harness from being caught between parts.
3. Clamp wire harness securely and make sure
that it does not contact sharp edge of any
part.
7-6
4. When connecting heater hoses, route them
correctly making sure they are free from
twist.
[For right hand steering vehicle]
Heater valve
[For left hand steering vehicle]
Fig. 7- 10
5. Refill the proper coolant. Refer to section 6.
Heater outlet hose
From intake inlet pipe
manifold
V
To water
From intake
inlet pipe
manifold