2) Fit counter shaft front circlip into groove in
shaft.
Fig. 13-58
3) Install counter shaft reverse gear and 5th
gear onto counter shaft. And then drive
counter shaft rear bearing onto it.
Fig. 13-59
4) Install idle gear and washer onto reverse
gear shaft and pin into it.
Install above as assembled into lower case
with pin (ij and washer tongue @ aligned as
shown below.
Fig. 13-60
Fig. 13-61
Shifter Forks, Shafts and Yokes
[Forks and Shafts]
Fig. 13-62
Low speed gar shift shaft
High speed gear shift shaft
13-19