Oil Pump Strainer; Oil Pan; Applying Sealant To Oil Pan; Oil Level Gauge Guide - Suzuki Samurai 1986 Service Manual

Oil Pump Strainer

Install seal in the position shown in Fig. 3-6-22.
Tighten strainer bolt first and bracket bolt to
specified torque.
Tightening torque
for bolts
Fig. 3-6-22 Installing seal

Oil Pan

1) Clean mating surfaces of oil pan and cylinder
block. Remove oil, old sealant, and dusts
from mating surfaces.
After cleaning, apply silicon type sealant to
oil pan mating surface continuously as
shown in Fig. 3-6-23.
Fig. 3-6-23 Applying sealant to oil pan
3-42
9 - 12 N.m
0.9 - 1.2 kg-m
6.5 - 8.5 lb-ft
1 . Seal
2. Strainer
3. Bracket
Sealant MOOO-31150)
2) Install oil pan to cylinder block.
After fitting oil pan to block, run in secur-
ing bolts and start tightening at the center:
move wrench outward, tightening one bolt
at a time.
Tighten bolts to specified torque.
Tightening torque
for oil pan bolts
3) Install gasket and drain plug to oil pan.
Tighten drain plug to specified torque.
Tightening torque
for drain plug
4) Install guide seal to pump case and then oil
level gauge guide.
Fig. 3-6-24 Oil level gauge guide
Flywheel
Install flywheel to crankshaft.
Using special tool, lock flywheel, and tighten
flywheel bolts to specification.
Tightening torque
for flywheel bolts
1.2 kg-m
0.9
7.0 - 8.5 lb-ft
30 - 40 N.m
3.0 - 4.0 kg-m
22.0 - 28.5 lb-ft
1. Oil pump

2. Oil level gauge guide

3. Guide bolt
4. Guide seal
5 7 6 5 N-m
5.7 6.5 kg-m
41.5 - 47 lb-ft