Suzuki Samurai 1986 Service Manual page 298

2) Using spring pin remover (special tool), drive
2 spring pins out of front drive shift shaft
remover @ : (09922-85811).
Spring pin
Fig. 14-24
3) Remove forks and shift shafts.
NOTE:
At this time, locating ball and spring will jump
out of hole, use care not to lose them.
Fig. 14-25
4) Hammer output rear shaft with
hammer to drive it out of center
14-10
a
plastic
case.
Fig. 14-26
5) Pull out counter gear,
Remove counter shaft
loosening counter shaft
Fig. 14-27
6) Remove input shaft from center case by
hammering thick part of case or input
shaft center with a plastic hammer.
Fig. 14-28
bearings and spacer.
from center case by
lock plate bolt.