Front Brake Disc And Pad; Front Wheel Spindle; Front Brake Flexible Hose - Suzuki Samurai 1986 Service Manual

Fig. 19-36

Front Brake Disc and Pad

Use care not to scratch or put oil or grease
on sliding surface of disc and pad during
installation work.
After installing brake disc to wheel hub
properly, tighten wheel nuts to specified
torque.

Front Wheel Spindle

Apply SEALING COMPOUND 366E (99000-
31090) to mating surfaces of brake caliper
holder and steering knuckle.
Dust
When fitting dust cover onto brake caliper
holder, apply SEALING COMPOUND 366E
(99000-31090) to mating surfaces of both parts.

Front Brake Flexible Hose

Connect flexible hose to caliper as shown
below and tighten hose bolt to specified
torque.
Connect the other end of hose to chassis body
bracket, being careful not to kink it with
front wheels directed straightforward.
Viewed in errow "E"
direction
Fig. 19-38
Flexible hose
Front side
Viewed in arrow "D" direction
Fig. 19-37
Tightening torque
F a s t e n i n g p a r t s
Flexible hose bolt
Carrier bolt
Caliper holder bolt
Caliper guide pin
Wheel nut
NOTE:
After completing installation, fill reservoir with
brake fluid and bleed brake system. Perform
brake test and check each installed part for oil
leakage.
nter side
kg-m
N - m
(lb-ft)
2.0 - 2.5
20 - 25
(14.5 - 18.0)
7.0- 10.0
70 -100
(51.0 -72.0)
4.0- 6.0
40 - 60
(29.0 - 43.0)
25 - 30 2.5 - 3.0
(18.5 - 21.5)
5.0 - 8.0
(36.5 - 57.5)
19-19