Creating Physical Disk Resources; Cluster Resources Page - HP ProLiant 300 Series Administration Manual
Hide thumbs
Also See for ProLiant 300 Series:
- Introduction manual (22 pages) ,
- Troubleshooting manual (194 pages)
Table of Contents
Advertisement
Creating physical disk resources
A physical disk resource must reside within a cluster group. An existing cluster group can be used or a
new cluster group must be created. See
To create a physical disk resource:
1.
On the Cluster tab, click Cluster Resources.
Figure 98 Cluster Resources page
2.
Click Create.
3.
On the Welcome Page click Next.
4.
Specify a name for the cluster resource and enter a description for the resource.
5.
Select the Cluster group the physical disk will reside in.
6.
Select Physical Disk as the resource type, and then click Next.
7.
Select the Possible Owners, and then click Next.
8.
Set the dependencies, and then click Next.
NOTE:
Physical disk resources usually do not have any dependencies set.
9.
Specify the available disk resource, and then click Next.
10.
Review the configuration, and then click Finish to create the physical disk resource.
11.
After the resource is created it is necessary to bring it online. In the Cluster Resources page,
select the resource and click Bring Online.
12.
Click OK on the Bring a Resource Online page to bring the new physical disk resource online.
192
Cluster Administration
"Creating a new cluster
group" earlier in this chapter.
Advertisement
Table of Contents
