HP ProLiant 300 Series Administration Manual page 120

1. Select Start > Settings > Control Panel, double-click Administrative Tools, and then
double-click Manage Your Server.
2. Click Add or Remove a Roll.
A wizard starts.
3. Click Next.
4. Select Printer Server in the list of Server Roles, and then click Next.
5. Select Windows 2000 and Windows XP clients only, and then click Next.
NOTE:
While the "All Windows" support may be selected at this step, it is more efficient to add the
alternative operating systems on each printer after the wizards are complete. See
operating system support."
6. Click Next on the Summary page to start the Add Printer Wizard.
7. Select Local Printer, clear "automatically detect install my plug and play printers," and then click
Next.
NOTE:
Local Printer is used to create a TCP/IP port connection to a network enabled printer over the
network. The storage server only supports network attached printers and does not support directly
connected printers via USB or Parallel Port.
8. Select Create a new port, and then select Standard TCP/IP Port (recommended).
The Add Standard TCP/IP Printer Port Wizard starts.
9. Click Next.
10. Enter the name or IP address of the printer. The IP address is usually listed on the printer configuration
page. The wizard completes the Port Name field. Click Next.
11. The wizard attempts to connect to the printer. If the wizard is able to connect, the Completing the
Add Standard TCP/IP Printer Port Wizard page opens; click Finish. If the wizard is not able
to connect, the Additional Port Information Required page opens.
a. Verify that the IP address or name is correct.
b. Select Standard to identify the printer network adapter. A list of manufacturers
and models of the network adapters is displayed. Select the appropriate printer in
the Standard list.
c. If the printer network adapter uses nonstandard settings, click Custom, and then
click Settings. The Configure Standard TCP/IP Port Monitor page opens.
Specify the settings that are recommended by the manufacturer of the printer
network adapter, and then click OK.
d. Click Next.
120
Folder, Printer, and Share Management
"Adding additional