HP ProLiant 300 Series Administration Manual page 122

4. Click Next.
NOTE:
Local Printer is used to create a TCP/IP port connection to a network enabled printer over the
network. The storage server only supports network attached printers and does not support directly
connected printers via USB or Parallel Port.
5. Click Create a new port, and then select Standard TCP/IP Port (recommended).
The Add Standard TCP/IP Printer Port wizard starts.
6. Click Next.
7. Enter the name or IP address of the printer. The IP address is usually listed on the printer configuration
page. The wizard completes the Port Name field. Click Next.
8. The wizard attempts to connect to the printer.
• If the wizard is able to connect, the Completing the Add Standard TCP/IP Printer
Port wizard page opens. Click Finish.
• If the wizard is not able to connect, the Additional Port Information Required page
opens:
a. Verify that the IP address or name that was entered is correct.
b. Select Standard to identify the printer network adapter. A list of manufacturers
and models of the network adapters is displayed. Select the appropriate printer
from the Standard list.
c. If the printer network adapter uses nonstandard settings, click Custom, and
then click Settings. The Configure Standard TCP/IP Port Monitor page
appears. Specify the settings that are recommended by the manufacturer of the
printer network adapter, and then click OK.
d. Click Next.
9. Select the manufacturer and the type of printer in the presented list, and then click Next. If the
printer does not exist in the list, click have disk and load the drivers or select a compatible driver.
NOTE:
On models having print services available, additional print drivers are located on the storage server
in the c:\hpnas\components\HP Storage Server Print Drivers folder.
10. Enter the name of the desired printer to be presented on the storage server, and then click Next.
11. Enter a Share Name for the printer that will used on the network, and then click Next.
12. Enter a location description and a comment, and then click Next.
13. Select Print a test page, and then click Next.
14. Click Finish.
A test page prints.
122
Folder, Printer, and Share Management