Adding New Storage To A Cluster; Cluster Groups Page - HP ProLiant 300 Series Administration Manual
Hide thumbs
Also See for ProLiant 300 Series:
- Introduction manual (22 pages) ,
- Troubleshooting manual (194 pages)
Table of Contents
Advertisement
Figure 97 Cluster Groups page
2.
Click Create to create a new group.
3.
Specify the properties for the new cluster group, and then click OK to create the cluster group.
Adding new storage to a cluster
Present the new storage to one node in the cluster. This can be accomplished through selective storage
presentation or through SAN switch zoning.
1.
Open the WebUI and navigate to the Disks tab.
2.
Click the Disks subtab.
3.
Select the disk that needs to be configured from the list of available disks, and then click Create
New Volume.
4.
Follow the steps in the wizard to create the new volume. The LUN needs to be configured as a
basic disk with a NTFS file system.
NOTE:
If the disk does not appear in the list of available disks on the Manage Disks page then click Rescan
to rescan for new disks and refresh the page.
5.
Open the WebUI and click the Cluster tab.
6.
Follow the procedures listed below to create a physical disk resource.
See the Cluster Storage Guide on the WebUI Cluster tab for detailed information on adding
storage elements into the cluster.
HP ProLiant Storage Server administration guide
191
Advertisement
Table of Contents
