ABB Relion 670 Series Applications Manual page 380

Section 13
Control
StopAtExtremes : Sets the behavior of the switch at the end positions – if set to Disabled , when
pressing UP while on first position, the switch will jump to the last position; when pressing DOWN
at the last position, the switch will jump to the first position; when set to
allowed.
13.7 Selector mini switch VSGAPC
13.7.1 Identification
Function description
Selector mini switch
13.7.2 Application
Selector mini switch (VSGAPC) function is a multipurpose function used in the configuration tool
in PCM600 for a variety of applications, as a general purpose switch. VSGAPC can be used for both
acquiring an external switch position (through the IPOS1 and the IPOS2 inputs) and represent it
through the single line diagram symbols (or use it in the configuration through the outputs POS1
and POS2) as well as, a command function (controlled by the PSTO input), giving switching
commands through the CMDPOS12 and CMDPOS21 outputs.
The output POSITION is an integer output, showing the actual position as an integer number 0 – 3.
An example where VSGAPC is configured to switch Autorecloser enabled–disabled from a button
symbol on the local HMI is shown in
normally used for enable–disable operations of the circuit breaker.
INTONE
Disabled
Enabled
ANSI07000112 V3 EN-US
Figure 179: Control of Autorecloser from local HMI through Selector mini switch
VSGAPC is also provided with IEC 61850 communication so it can be controlled from SA system as
well.
374
IEC 61850
identification
VSGAPC
figure
VSGAPC
PSTO
IPOS1
IPOS2
NAM_POS1 CMDPOS12
NAM_POS2 CMDPOS21
IEC 60617 ANSI/IEEE C37.2
identification device number
-
179. The Close and Open buttons on the local HMI are
INV
OUT
INPUT
SMBRREC_79
ON SETON
OFF
ANSI07000112-3-en.vsd
1MRK 511 358-UUS A
Enabled , no jump will be
SEMOD158754-1 v3
-
SEMOD158803-5 v6
Application manual
SEMOD167850-2 v3