Bit Memory Table Write Command (Sent From Host To Pt) - Omron NT631 Series Reference Manual

Commands/Responses
Response
Format
Function
4-3-10 Bit Memory Table Write Command
Command
Format
374
Downloaded from Elcodis.com electronic components distributor
Reference: The maximum number which can be specified for character string memory table
depends on the setting for numbers of character string table entries
(256/1000/2000) made at the Support Tool. However, it is not possible to write to
character string memory table of numbers higher than No.500 since they are
used only as a reading area.
Only if Yes is set for the Response memory switch, the response indicated below
is returned on normal completion.
[ESC]
s , s :
1 2
Writes specified data to the specified character string memory tables.
[ESC]
1B 57
Data of 16 tables
d11
* *
m :
t to t :
1 4
l , l :
1 2
d1 to d1 , ..., dn
1 4
s , s :
1 2
W S 0
1B 57 53 30
Check sum (2 hexadecimal digits)
This is always added (fixed as 25H).
W B m t1
t2
42
* * * * * * * *
Data of 16 tables
,
d14 dn1
2C
* * * *
Check sum present/absent (1 BCD digit)
0 : Absent
1 : Present
8 : Absent (effective only when 1 table written)
9 : Present (effective only when 1 table written)
First bit memory table number written to (4 BCD digits)
0000 to 0999
Number of written tables (2 BCD digits)
00 :100 tables
01 to 99 :1 to 99 tables
When m is 8 or 9, omit this setting.
to dn :
1 4
Contents of the written bit memory tables (4 hexadecimal dig-
its, × n)
0000 to FFFF
H
The contents of bit memory table are represented as 1 bit data
(OFF=0, ON=1) and 16 entries of bit memory table are speci-
fied as 4 hexadecimal digits value. (Table entries with smaller
number is the rightmost bit.)
If written data is less than 16, the specification is started from bit
0. (Remaining leftmost bit will be ignored.)
The bit memory table data (4 hexadecimal digits) is delimited by
commas by each 16 tables.
Check sum (2 hexadecimal digits)
When m is 0 or 8, omit this setting.
Section
0 s1 s2 [CR]
30 32 35 0D
(Sent from Host to PT)
t3 t4 (l1) (l2)
* * * * * * * *
dn4 (s1) (s2)
* * * * * *
4-3
[CR]
0D