Step 1: Prepare The Site For Installation - Juniper ACX1000 Quick Start Manual

Figure 3: Front Panel of the DC-Powered ACX1100 Router
DC terminals
1
—
Management Ethernet port
2
—
3 Alarm input and output contacts
—
4 Gigabit Ethernet (GE) ports
—
5 Combination Gigabit Ethernet RJ-45 ports
—
ESD point
6
—

Step 1: Prepare the Site for Installation

Prepare your site for installation by observing the following guidelines:
• You can install the router in a four-post rack or cabinet or an open-frame rack.
• The rack rails must be spaced widely enough to accommodate the chassis's external dimensions:
1.75 in. (4.4 cm) high, 9.4 in. (24 cm) deep, and 17.5 in. (44 cm) wide. The outer edges of the
mounting brackets extend the width to 19.2 in. (48.7 cm).
• One person must be available to lift the router while another secures the router to the rack.
• The rack must be strong enough to support the weight of the fully configured router, up to 7 lb
(3.2 kg).
• For service personnel to remove and install hardware components, allow at least 2.16 in. (5.5 cm) in
front of the router.
• The rack or cabinet must have an adequate supply of cooling air.
Combination Gigabit Ethernet SFP ports
7
—
1-PPS and 10-MHz input and output
8
—
9 Console or auxiliary port
—
10 USB port
—
11 System (SYS) LED
—
Grounding terminals
12
—
3