Converting The Speedometer; Hydraulic System Maintenance; Hydraulic System Safety; Checking The Transaxle/Hydraulic-Fluid Level - Toro Workman HDX-D 07385 Original Instructions Manual

Converting the
Speedometer
You can convert the speedometer from mph to km/h
or km/h to mph.
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Remove the hood; refer to
(page 37).
3. Locate the 2 loose wires next to the
speedometer.
4. Remove the connector plug from the harness
wire and connect the wires together.
Note:
The speedometer switches to km/h or
mph.
5. Install the hood.
Removing the Hood
55
Hydraulic System
Maintenance

Hydraulic System Safety

•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Before disconnecting or performing any work on
the hydraulic system, relieve all pressure in the
system by shutting off the engine, cycling the
dump valve from raise to lower, and/or lowering
the cargo bed and attachments. Place the remote
hydraulics lever in the float position. Do not work
under a raised bed without the proper bed safety
support in place.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and that all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your hands and body away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
Checking the
Transaxle/Hydraulic-Fluid
Level
Service Interval: Before each use or daily—Check
the transaxle/hydraulic-fluid level.
(Check the fluid level before the
engine is first started and every 8
hours or daily, thereafter.)
Transaxle-fluid type: Dexron III ATF
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the dipstick (Figure 64).