Fuel Gauge; Horn Button - Toro Workman HDX-D 07385 Original Instructions Manual

Coolant-Temperature Gauge and
Light
The coolant-temperature gauge and light registers the
coolant temperature in the engine and operates only
when the key switch is in O
indicator light blinks red if the engine overheats.
Charge Indicator
The charge indicator illuminates when the battery
discharges. If the light illuminates during operation,
stop the machine, shut off the engine, and check for
possible causes, such as the alternator belt
Important:
If the alternator belt is loose or
broken, do not operate the machine until the
adjustment or repair is complete. Failure to
observe this precaution may damage the engine.
Check the operation of the warning lights as follows:
•
Engage the parking brake.
•
Turn the key switch to the O
but do not start the engine. The coolant
temperature, charge indicator, and oil-pressure
lights should glow. If any light does not function,
either a bulb is burned out or there is a malfunction
in the system that you must repair.

Fuel Gauge

The fuel gauge shows the amount of fuel in the tank.
It displays only when key switch is in the O
(Figure 5). The red segment of the display indicates a
low-fuel level and the flashing red light indicates that
the fuel in the tank is near empty.
4-Wheel Drive Switch
4-Wheel Drive Models Only
When the 4WD switch
automatically engages the 4-wheel drive if the sensor
detects the back wheels spinning freely. When the
4-wheel drive is engaged, the 4WD switch light turns
on.
High-Flow Hydraulics Switch
TC Models Only
Turn on the switch to activate the high-flow hydraulics
(Figure 5).

Horn Button

TC Models Only
Pressing the horn button activates the horn
Press the horn button to sound the horn.
position (Figure
N
(Figure
/P position,
N REHEAT
position
N
(Figure 5) is on, the machine
(Figure
Tachometer
The tachometer displays the speed of the engine
(Figure 5 and
Note:
The white triangle indicates the desired engine
5). The
speed for 540 rpm PTO operation.
5).
1. Engine speed (rpm)
Speedometer
The speedometer registers the ground speed of the
machine (Figure
you can easily convert it to km/h; refer to
the Speedometer (page
Power Point
Use the power point
V electrical accessories.
5).
17
Figure 9).
Figure 9
2. 3,300 rpm for 540 rpm
PTO operation
5). The speedometer is in mph, but
55).
(Figure 5) to power optional 12
g010514
Converting