Toro Workman HDX-D 07385 Original Instructions Manual page 32

Maintenance Service
Interval
Every 800 hours
Every 1,000 hours
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a copy of the electrical schematic by visiting www.Toro.com and searching for your machine
from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
Only qualified and authorized personnel should maintain, repair, adjust, or inspect the machine.
• Avoid fire hazards and have fire-protection equipment present in the work area. Do not use
an open flame to check fluid levels or leakage of fuel, battery electrolyte, or coolant.
• Do not use open pans of fuel or flammable cleaning fluids for cleaning parts.
WARNING
Failure to properly maintain the machine could result in premature failure of machine systems
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
CAUTION
If you leave the key in the key switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the key switch before you do any maintenance.
Maintenance Procedure
• Change the front differential oil (4-wheel drive models only).
• Change the hydraulic fluid and clean the strainer.
• Replace the hydraulic filter.
• Change the high-flow hydraulic fluid and filter (TC models only).
• Flush/replace the coolant system fluid.
• Change the brake fluid.
32