Removing The Full Bed; Installing The Full Bed - Toro Workman HDX-D 07385 Original Instructions Manual

Removing the Full Bed

1. Start the engine, engage the hydraulic-lift lever,
and lower the bed until the cylinders are loose
in the slots.
2. Release the lift lever and shut off the engine.
3. Remove the lynch pins from the outer ends of
the cylinder rod clevis pins
Figure 23
1. Cylinder rod end
2. Bed-mounting plate
3. Clevis pin
4. Remove the clevis pins securing the cylinder rod
ends to the bed-mounting plates by pushing the
pins toward the inside
5. Remove the lynch pins and clevis pins securing
the pivot brackets to the frame channels
23).
6. Lift the bed off the machine.
CAUTION
The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove
it by yourself.
Use an overhead hoist or get the help of
2 or 3 other people.
7. Store the cylinders in the storage clips.
8. Engage the hydraulic lift-lock lever on the
machine to prevent accidental extension of the
lift cylinders.
(Figure 23).
g002368
4. Lynch pin
5. Rear slots (full bed)
6. Front slots (2/3 full bed)
(Figure 23).
(Figure

Installing the Full Bed

Note:
If you are installing the bed sides on the flat
bed, it is easier to install them before installing the
bed on the machine.
Ensure that the rear pivot plates are bolted to the bed
frame/channel so that the lower end angles to the rear
(Figure 24).
1. Left, rear corner of bed
2. Machine frame channel
3. Pivot plate
CAUTION
The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove it
by yourself.
Use an overhead hoist or get the help of 2 or 3
other people.
Ensure that the spacer brackets and wear blocks
(Figure 25) are installed with the carriage-bolt heads
positioned inside the machine.
35
Figure 24
4. Clevis pin
5. Lynch pin
g002369