Adjusting The Accelerator Pedal - Toro Workman HDX-D 07385 Original Instructions Manual

Figure 60
1. Clutch pedal
Note:
Force is applied so that the clutch-release
bearing lightly contacts the pressure-plate
fingers.
4. Tighten the jam nuts after you attain the proper
adjustment.
5. Check the 9.2 to 9.8 cm (3-5/8 to 3-7/8 inches)
dimension after the jam nuts have been
tightened to ensure proper adjustment.
Note:
Adjust again, if necessary.
6. Connect the return spring to the clutch lever.
Important:
Ensure that the rod end is
positioned squarely on the ball, not twisted,
and remains parallel to the clutch pedal after
the jam nut is tightened
Note:
The clutch free play should never be less
than 19 mm (3/4 inch).
Figure 61
1. Clutch-cable rod end
2. Clutch pedal
g009276
2. 9.2 to 9.8 cm (3-5/8 to
3-7/8 inches)
(Figure 61).
g009277
3. Rod end jam nut
4. Parallel
Adjusting the Accelerator
Pedal
1. Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2. Adjust the ball joint on the accelerator cable
(Figure 62) to allow 2.54 to 6.35 mm (0.100 to
0.250 inch) of clearance between the accelerator
pedal arm and the top of the diamond tread floor
plate (Figure 63), when you apply 11.3 kg (25 lb)
of force to the center of the pedal.
Note:
The engine must not be running and the
return spring must be attached.
3. Tighten the locknut
1. Locknut
1. 2.54 to 6.35 mm (0.100 to 0.250 inch) clearance
Important:
The maximum high-idle speed is 3,650
rpm. Do not adjust the high-idle stop.
54
(Figure 62).
Figure 62
2. Accelerator cable
Figure 63
g019537
g002412