Fuel System Maintenance; Servicing The Fuel Filter/Water Separator; Inspecting Fuel Lines And Connections - Toro Workman HDX-D 07385 Original Instructions Manual

Fuel System
Maintenance
Servicing the Fuel
Filter/Water Separator
Draining the Fuel Filter/Water
Separator
Service Interval: Before each use or daily—Drain
water or other contaminants from
the water separator.
1. Place a clean container under the fuel filter
(Figure 38).
2. Loosen the drain plug on the bottom of the filter
canister.
Figure 38
1. Filter canister
3. Tighten the drain plug on the bottom of the filter
canister.
Changing the Fuel Filter
Service Interval: Every 400 hours—Replace the fuel
1. Drain the water from the water separator; refer
to Draining the Fuel Filter/Water Separator
(page 43).
2. Clean the area where the filter mounts
38).
3. Remove the filter and clean the mounting
surface.
4. Lubricate the gasket on the filter with clean oil.
5. Install the filter by hand until the gasket contacts
mounting surface, then rotate it an additional 1/2
turn.
6. Tighten the drain plug on the bottom of the filter
canister.
Inspecting Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever
Inspect the fuel lines, fittings, and clamps for signs of
leaking, deterioration, damage, or loose connections.
Note:
Repair any damaged or leaking fuel system
component before using the machine.
g007367
43
filter.
comes first)
(Figure