1. Latch handle
2. Latch gate
Starting the Engine
1.
Sit on the operator's seat and engage the
parking brake.
2.
Disengage the PTO and high-flow hydraulics (if
equipped) and move the hand-throttle lever to
the O
position (if equipped).
FF
3.
Move the shift lever to the N
press the clutch pedal.
4.
Ensure that the hydraulic-lift lever is in the center
position.
5.
Keep your foot off the accelerator pedal.
6.
Rotate the key switch to the O
Note:
When the glow-plug-indicator light turns
on, the engine is ready to start.
7.
Rotate the key switch to the S
Note:
Release the key immediately when the
engine starts and allow it to return to the R
position.
Note:
The glow-plug indicator turns on for an
additional 15 seconds when the switch returns to the
R
position.
UN
Note:
Do not run the starter motor more than 10
seconds at a time or premature starter failure may
Figure 16
3. Latch pin
position and
EUTRAL
position.
N
position.
TART
result. If engine fails to start after 10 seconds, turn
the key to the O
starting procedure, wait 10 additional seconds, and
repeat the starting operation.
Engaging the 4-Wheel Drive
4-Wheel Drive Models Only
To enable automatic 4-Wheel Drive, press the top of
the rocker switch into the 4
17).
g026141
1. 4x4 auto enable—on
When the 4WD switch is on, the machine automatically
engages the 4-wheel drive if the sensor detects the
back wheels spinning freely. When the 4-wheel drive
is engaged, the 4WD switch light turns on.
Important:
not automatically engage the 4-wheel drive.
In reverse, you must manually engage the 4-wheel
drive using the 4WD button.
To engage the 4-wheel drive manually, press and
hold the 4WD button on the center console while the
vehicle is in motion and the 4-wheel drive engages.
Note:
The 4-wheel drive remains engaged only as
long as you hold the button; the 4WD switch does not
need to be in the A
the 4-wheel drive.
UN
25
position. Check the controls and
FF
4 A
X
UTO
Figure 17
2. 4x4 auto enable—off
When in reverse, the machine does
position to manually engage
UTO
position
(Figure
g227244