Raising The Machine - Toro Workman HDX-D 07385 Original Instructions Manual

Figure 25
1. Wear block
2. Spacer bracket
1. Ensure that the lift cylinders are fully retracted.
2. Carefully set the bed onto the machine frame,
aligning the rear bed pivot-plate holes with the
holes in the rear frame channel, and install the 2
clevis pins and lynch pins
3. With the bed lowered, secure each cylinder rod
end to the appropriate slots in the bed-mounting
plates with a clevis pin and lynch pin.
4. Insert the clevis pin from outside of the bed with
the lynch pin oriented toward the outside
25).
Note:
The rear slots are for a full bed
installation; the front slots are for a 2/3-full bed
installation.
Note:
You may need to start the engine to
extend or retract the cylinders for alignment with
the holes.
Note:
You can plug the unused slot with a bolt
and nut to prevent assembly errors.
5. Start the engine and engage the hydraulic-lift
lever to raise the bed.
6. Release the lift lever and shut off the engine.
7. Install the bed-safety support to prevent
accidentally lowering the bed; refer to
Bed Support (page
8. Install the lynch pins to the inside ends of the
clevis pins.
Note:
If the automatic tailgate release is
installed on the bed, ensure that the front dump
link rod is placed on the inside of the left clevis
pin before you install the lynch pin.
3. Carriage bolt
(Figure 25).
(Figure
Using the
34).

Raising the Machine

DANGER
A machine on a jack may be unstable and slip
off the jack, injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack, as the engine vibration or
wheel movement could cause the machine
to slip off the jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is on a
g002370
jack.
When jacking up the front of the machine, always
place a wooden block (or similar material) between
the jack and the machine frame.
The jacking point at the front of the machine is located
under the front, center frame support
1. Front jacking points
The jacking point at the rear of the machine is located
under the axle
36
(Figure
Figure 26
(Figure 27).
26).
g009823